Step 2 - Enumeration Emulator Troubleshooting
30
•
List of Emulators User Guide
C. BHETHCFG
LAN560JTAGEmulator(BH‐LAN‐560)
Please use the LAN560 Configuration Utility to verify if the unit is operational.
If you have not configured your Blackhawk LAN560 emulator or setup the LAN560 network service
Please refer to your emulator documentations.
http://www.blackhawk-dsp.com/downloads/EMU_Docs.aspx#BH-LAN-560
The LAN 560 Configuration Utility is found under <CCS Install Dir>\Blackhawk\Utility\Lan560Diags
\bhethcfg.exe
i. Open the Utility and go to the Status Tab.
ii. Click on Refresh Button, if the unit is enumerate, then Available will be shown, else you will
be prompted with a corresponding error, or a NETBIOS name of the computer using this
resource.
Figure 31 LAN 560 Configuration Utility - Status Tab
⇒ PASS/FAIL
If the emulator is listed as available, continue to the next step.
if the emulator is listed not available or prompt with an error, refer back to the emulator setup
documentation. If you cannot pass this step successfully, report this information (step that failed)
to Blackhawk support and be sure to include the unit’s model and serial number. There is no
reason to continue with these procedures.
Commentaires sur ces manuels